Bob Kelly III
Ranch Kid from way back,.... that got Old !
I don't know about you gggGary ! whats wrong with the setup you had ? it worked didn't it ? HAHAHAHAH!
.....
Today I took off the left cover and took 100grit sand paper to it to get the oxidation and clear coat off of it..... it was slow going but in an hour or so I had it all cleaned up... I then took steel wool to it and wound up with a Satten finish...not shinie by any means but it looks better than it was.
....that and thinking... I bet the richness screws for the pilot circuit are set too lean for it to run correctly
.... I've looked but cannot find any adjustment screws on the side of those carbs...then Fredintoon mentioned they were behind caps...that would figure!!! so tomorrow I might try adjusting them a bit if I can get it to run agaiin... <GRIN>
Bob...........
.....
Today I took off the left cover and took 100grit sand paper to it to get the oxidation and clear coat off of it..... it was slow going but in an hour or so I had it all cleaned up... I then took steel wool to it and wound up with a Satten finish...not shinie by any means but it looks better than it was.
....that and thinking... I bet the richness screws for the pilot circuit are set too lean for it to run correctly
.... I've looked but cannot find any adjustment screws on the side of those carbs...then Fredintoon mentioned they were behind caps...that would figure!!! so tomorrow I might try adjusting them a bit if I can get it to run agaiin... <GRIN>
Bob...........