Just look for the most toxic carcinogen on the market , with the biggest warning label , promising pain , death and testicular shrinkage. That’s the one you want, that’s the one that will work the best.
Will do. Gimme a few days. I have a weird work schedule.JRAY, find out what epoxy they're using...
Nope... just a plain wound, round coil. You could literally do a one off by hand.......I always thought it was some crazy complex pattern
One end of the coil, from the innermost winding, has to emerge from the inner, and is in contact with each layer. Given that many failed rotors show 0 ohms, I wonder if that's a risk zone, possible abrasion creating dead short. Would it be worth it to have a thin dielectric film, or spaghetti tube, to isolate/protect that emerging wire?
Thanks.......fingers crossed Jimd for your prototype to perform and last!!! Great details and write up!
Sorry Steve, forgot to respond to this...... I put punch marks on the three parts before I pressed it apart. A simple matter of lining up the dots.When these 3 are reassembled, is the alignment of the keyway with the timing mark assured, or do you have to keep your wits about you?