Yup! Same here, just dug up a photo from when I rebuilt the starter.
I find that to be very interesting.
I find that to be very interesting.
So the big tell would be to compare starter gear ratios between the types. Anybody know if if the same geartrain was used in both?Yup! Same here, just dug up a photo from when I rebuilt the starter.
View attachment 128866
I find that to be very interesting.
Bob, when you get it running, it'd be interesting to compare decompression start to 2 cyl. start. If yours also starts easier on two.... you could just adjust the cable so that starter engages but decompress don't.
Lookin' good Bob!! You'll want to address this bit of interference before vibes get to it....
View attachment 128887
Tubes are either mild steel or brass. Can't remember which. At any rate... they'll "tweek" pretty easy. Try and get 1/16" - 1/8" clearance there.
My XS1 motor has JIS screws instead of bolts?Bonus round, 10 points to the person that can tell me what’s not correct in the photo of the breather. Test your XS knowledge!
Wrong angle on the tubes Yours are angled down a bit mine are straight out.