A couple of ball turners I made a few years ago. Just a project, only used it for making a Delrin panel hammer so far. I wanted one that could mount in the tool post and could be used either in front of or behind the chuck. The welded up one was just a trial, it worked well, so I made a few improvements to it. Again, all done on the lathe using a vertical slide.
Attachments
-
15675618_220352638415809_2969969817501947607_o.jpg177.9 KB · Views: 79
-
15665747_220804405037299_2357798175826586051_n.jpg78.9 KB · Views: 76
-
31369694_2040980742828628_8702552182144106496_n.jpg12.7 KB · Views: 76
-
15591255_220352618415811_2523932182159452129_o.jpg260.3 KB · Views: 73
-
15625981_220352588415814_3621266173501245755_o.jpg296.5 KB · Views: 77
-
107571566_2736509499942412_4136051651759921456_n.jpg230.6 KB · Views: 86
-
107644175_2736509626609066_8555685861629748379_n.jpg221.7 KB · Views: 80