Hi everyone,
I did some searching and couldn't find a thread covering this.
On my bike, I have the stock '72 master cylinder, caliper and brake line. I bought the TC Bros Custom Stainless Braided Brakeline to accomedate new bars and the greater distance between the master cylinder and the caliper.
I'm a bit stumped on how to make the line connect to the caliper. The kit includes two 10mm banjo fittings -- though, it seemed like one of these would bolt right-up to the master cylinder with the stock banjo bolt. I'm confused about how to attach the line to the caliper itself.
From master cylinder there is a rubber hose which connects to a lower steel line which then connects to the caliper. Generally, I don't know what the bottom banjo fitting from the kit should connect to, and what exact part/bolt I'd use to connect it if I did know.
I'm guessing many of you are familiar with the setup so pardon the long description, I've included photos as a reference.
Thank you in advance!
I did some searching and couldn't find a thread covering this.
On my bike, I have the stock '72 master cylinder, caliper and brake line. I bought the TC Bros Custom Stainless Braided Brakeline to accomedate new bars and the greater distance between the master cylinder and the caliper.
I'm a bit stumped on how to make the line connect to the caliper. The kit includes two 10mm banjo fittings -- though, it seemed like one of these would bolt right-up to the master cylinder with the stock banjo bolt. I'm confused about how to attach the line to the caliper itself.
From master cylinder there is a rubber hose which connects to a lower steel line which then connects to the caliper. Generally, I don't know what the bottom banjo fitting from the kit should connect to, and what exact part/bolt I'd use to connect it if I did know.
I'm guessing many of you are familiar with the setup so pardon the long description, I've included photos as a reference.
Thank you in advance!